WALL HEATERS
QFG Series - Electric Fan-Forced Wall Heaters
Instructions
Bulletin
Submittal
You MUST have Adobe Acrobat Reader to view any literature downloaded from this website.
RESIDENTIAL: QFG Series electric in-wall heaters are suitable for use in almost any room. Use single heaters in smaller rooms such as bedrooms and bathrooms. Use multiple heaters (controlled by a single thermostat) in larger rooms such as living rooms and family rooms. Wattage should be determined through heat loss calculations.

COMMERCIAL: Suitable as the primary heat source in smaller rooms and as supplemental heat in almost any general use area.

CLIP-N-FITŪ FEATURE          Patented Clip-N-FitŪ feature (US Patented No. 6,172,343) allows the installer to change the wattage of the heater to a lower output without moving jumper wire. Each heater is factory wired for its maximum wattage. To change wattage, clip out either jumper 1 or 2 as shown in the installation manual for desired wattage. This Patented Clip-N-FitŪ feature also prevents the operator to change wattage after installation to a higher wattage.

  • Dual Protection: Thermal cutout with indicator light and one time thermal fuse.

  • Tangential blower for whisper quiet operation.

  • Sienna White baked enamel finish.

  • Open coil element assures quick heat and low maintenance.

  • Three piece construction for ease of installation.

  • Permanently lubricated, dust protected bearings.

  •  For more information see Bulletin.

More Wall Heaters
For pricing, see Rep. Locator under the Contact pull-down menu at top of page.